NEC Xen IPK Programming Manual page 71

Xen IPK
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
AH
Press the corresponding CO/PBX line key to change the tenant number.
3
Speed Dial buffers have nine groups. These groups are listed in the table
Speed Dial
Buffer No.
80 Codes
0X
1X
6X
7X
8X
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
S
to move to the next page
T
to move to the previous page
Each time a CO/PBX line key is pressed, the LED toggles between On and Off.
CO/PBX
Line LED
Data
After entering all pages for the selected Speed Dial Buffer No., press
4
No. is displayed.
5 After entering data for all of the Speed Dial Buffer Nos., press
next Memory Block is displayed.
P
6 Press to go back on-line.
Related Programming
M.B. Number
1-1-33 Speed Dial Number/Name Display Selection
1-1-35 Speed Dial Buffer Allocation
2-01 Trunk to Tenant Assignment
4-09 Telephone to Tenant Assignment
1-1-18, System Speed Dial Restriction by Tenant
to access the Memory Block.
Speed Dial Number
1000 Codes
00~09 000~099
10~19 100~199
60~69 600~699
70~79 700~799
N/A 800~899
Off
Restricted Not restricted
X = Any digit 0~9
On
N
to write the data. The next Speed Dial Buffer
N
to write the data for the last Speed Dial Buffer No. The
Memory Block Name
Programming Manual
Default Values
All System Speed Dial buffers can
be dialled from any tenant.
DRAFT 3
Chapter 1 – 51