Caller Id Display Assignment For Co/Pbx Line - NEC Xen IPK Programming Manual

Xen IPK
Caller ID Display Assignment
for CO/PBX Line
General Description
Use this Memory Block to assign one Multiline Terminal, per CO/PBX, line to display Caller ID
Indication on incoming CO/PBX calls.
Display
CO/PBX
No.
Data
(01~64)
No.
0 1 / 4 4 : C A L L I D
T I M E
Programming Procedures
1 Go off-line.
N
Press LK3 + +
2
3 Enter data using the dial pad.
Note: The following are used when entering data:
J to move the cursor left
L
to move the cursor right
K ~ I to enter numeric data
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
M.B. Number
Refer to Chapter 2, Guide to Feature Programming.
N
To display Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID Indication and Ring
assignment must be assigned for the terminal in System Programming. A maximum of 15 Multiline Terminals can be
assigned system-wide to display caller identification for normal incoming CO calls and CAR incoming calls using Memory
Block , 1-1-78 , Caller ID Display Assignment for System Mode. A third Multiline Terminal can be assigned to display
caller identification for normal incoming CO calls, per CO line, using this Memory Block.

3-44, Caller ID Display Assignment for CO/PBX Line

Tel
Port No.
Title 01~C0
0 0
D I S P L A Y
to access the Memory Block.
DD
Default Values
Not Specified
Memory Block Name
Programming Manual
System Mode
3
Submode
—
Data No.
44
PC Programming
+ BCT
DRAFT 3
Chapter 1 – 383
3-44