Clear Channel Selection - NEC Xen IPK Programming Manual

December 2004

Clear Channel Selection

General Description
Use this Memory Block to specify the clear channel selection. when the Zero Byte Time
channel is available, the CLKG-U( ) Unit cannot extract a clock signal from the T1
trunk. The T1 trunk modifies the Zero Byte Time channel to extract a clock signal for the
CLKG-U( ) Unit
.
Applicable for R2000 and above.
Display
DTI No. Data
(01~08) No.
0 1 / 0 1 : O B Y T E = Z C S
T I M E
Settings
LK1 LK2
ZCS B8ZS
Programming Procedures
Go off-line.
1
2 Press LK1 + LK11 + KA
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
N
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
DRAFT 3
262 – Chapter 1
Setting
Data
Title
D I S P L A Y
LK3 LK4 LK5
to access the Memory Block.
P
to go back on-line.
LK6 LK7
Memory Block Name
NEC Business Solutions Ltd
1-11-01
System Mode
1
Submode
11
Data No.
01
PC Programming
+ AD
LK8
The shaded area indicates
the default setting.
Clear Channel Selection, 1-11-01