SL1100
Table 2-6 RJ61 Cable Connector Pin-Outs (J101-J103)
8 765 4321
1.6.5 Cable Routing and Clamping
1. Depending on cabling requirement, select either a right or left route. Clamp and route cable to
outside.
2. Cut and remove the Plastic Knockouts as needed from the Sub-Cover.
Sub-Cover
3. Replace the Sub-Cover.
2-16
Pin No.
ESI 1-4 (J101), ESI 5-8 (J102):
2-Wire Digital Extension Port
Connector (RJ-61)
1
T4 (Tip for port 4)
2
T3 (Tip for port 3)
3
T2 (Tip for port 2)
4
R1 (Ring for port 1)
5
T1 (Tip for port 1)
6
R2 (Ring for port 2)
7
R3 (Ring for port 3)
8
R4 (Ring for port 4)
Figure 2-23 Cabling
Figure 2-24 Sub-Cover
SLI 9-12/DPH 1-2 (J103): Analog
Extension Port Connector
(RJ-61)
T4 (Tip for port 4)
T3 (Tip for port 3)
T2 (Tip for port 2)
R1 (Ring for port 1)
T1 (Tip for port 1)
R2 (Ring for port 2)
R3 (Ring for port 3)
R4 (Ring for port 4)
Cable clamp
Cables
Plastic Knockouts
ISSUE 1.0
Installation