Installing The Cf Card (Cfvms/Cfvml); Table 2-20 Operation Of Voipdb Led Indications; Figure 2-87 Installing The Cf Card - NEC SL1100 Hardware Manual

SL1100
LED
LINK100 100Base-TX link speed indicator.
LINK10 10Base-TX link speed indicator.
ACT LINK1000
Off Off
Off On
On On
On Off
Flash

4.2 Installing the CF Card (CFVMS/CFVML)

• Do not remove or install the CPU Card with the power on.
• If Expansion KSU(s) are installed, turn the power on/off in the order of Expan-
sion 2 KSU, Expansion 1 KSU and then Main KSU.
• When installing a compact flash card onto the VMDB the system MUST be
powered off. Never install or uninstall the compact flash card while the system
is under power.
1. Turn off the system power and disconnect AC cord.
2. Remove the CPU card and insert the compact flash card into the CF slot (CN2).
3. Reinstall the CPU card into the 084M-B1 mother board, and close the CPU Support making sure
tab A locks into place.
2-56
Function LED Status

Table 2-20 Operation of VOIPDB LED Indications

LED
LINK100 LINK10
Flash Flash
Flash Flash
Flash Flash
Flash Flash
Blinking one by one
CF card

Figure 2-87 Installing the CF Card

Operation status
On Red Lights up when 100Base-TX link up.
On Red Lights up when 10Base-T link up.
Operation status
Internal Error (Hardware Error)
State of half duplex transmission (Not support)
Please change HUB etc. to full duplex transmission.
The firmware is being updated.
CPU card
CF Slot (CN2)
VMDB
ISSUE 1.0
Installation