ISSUE 1.0
2.7 IP4WW-Battery Box to KSU Connection
To avoid damage to equipment, do not install the Topaz Battery Box (DX2E-
32i/NX7E Battery Box) to the SL1100 system.
• Make sure the system power is off.
• If Expansion KSU(s) are installed, turn the power on/off in the order of Expan-
sion 2 KSU, Expansion 1 KSU and then Main KSU.
1. Power off the KSU and disconnect AC cord.
2. Open the Sub-Cover of the KSU.
3. Cut and remove Plastic Knockout from the Sub-Cover to connect Battery cable.
Hardware Manual
Figure 2-51 KSU Mounting on Battery Box
Sub-Cover
Figure 2-52 Sub-Cover Open and Hold
Sub-Cover
Two screws
Push to hold
Open
SL1100
2-33