NEC 1080Xd User Manual page 88

cmd arg1
add pcixx
(cont'd)
delete -
<arg1>
enable -
pbayxy
3-38 Service Processor
Table 3-35. HC Subcommands (cont'd)
arg2 arg3 arg4
[bio]
- - -
- - -
- - -
- - -
Description
Adds a PCIV/PCIX Unit.
"x" is the DGI/I2C port number of the iSP-C
Board side (0-3).
If PCIV is specified, "0" must be specified to x.
If a PCiX Unit is specified, 1,2 or 3 must be
specified to x.
If the Basic I/O Board is attached, specify "bio"
as the second argument.
"bio" must be specified in the case of the
PCIX0(V).
IOR0 is installed on the XIC Board. But the
IOR0 is added when the PCIX0(V) is added to
realize the same operation as the PCIX Unit.
Used to delete a component from the iSP
management. If you do not delete it from the
iSP management, the component which has
been physically removed will still be managed
as "INVISIBLE".
You cannot delete any components in the DC
ON state (except Distributed Power Supply
Module (DPS)).
Displays Help for "delete" when the argument is
omitted or an error is made.
<arg1> is the same as described in "add".
Used to enable a component managed as
"DISABLE".
Displays Help for "enable" when the argument is
omitted or an error is made.
This subcommand can be executed in the DC
POWER OFF state of the partition that will use
the component.
When the online configuration and
deconfiguration function is released, this
restriction will be relieved.
Enables a Power Bay/Power Bay Unit.
"x" is the chassis number.
0: Power Bay in the Main/Expansion Chassis
1: Power Bay Unit
"y" is the ID number.
0 for the Power Bay in the Main Chassis
1 for the Power Bay in the Expansion Chassis
0 for the Power Bay Unit