Sp Command List - NEC 1080Xd User Manual

SP Command List

The following table lists the SP commands by category.
CMD Command Name
DF Shut Down System Power
(override)
DN Shut Down System Power
DP System Dump
PC Power Cycle
RS Cold Reset System
UP Bring Up System
Figure 3-4. System State Transitions and System Control Commands
3-14 Service Processor
Table 3-16. System Control Commands
Function
The iSP turns off the DC power of the
specified partition without notifying the SW
(OS) even if it is running.
If the specified partition is in SO state, the iSP
only generates the SCI(POWBTN). Otherwise,
the iSP turns off the DC power directly.
The iSP generates the INIT signal to the
specified partition. SW(OS) will enter its dump
routine.
The iSP turns off the DC power of the
specified partition without notifying the
SE(OS) even if it is running, turns on the DC
power, initializes HW and hands off the control
to the BIOS.
The iSP initializes the specified partition
without notifying the SW(OS) even if it is
running.
The iSP turns on the DC power of the
specified partition and initializes HW and
hands off the control to the BIOS. The BIOS
boots the operating system.
DC OF F
UP /P C
DN /DF
DF
P C
RS
UP /P C/RS
DC ON
N ot r u n n in g
NML
Mode
X
X
X
X
X
X
DN /DP
(on ly t r igger )
Rea dy
SW r u n n in g
MNT
Mode
X
X
X
X
X
X