NEC 1080Xd User Manual page 96

cmd arg1
mmcxy
clear
Displayed String
nonexist
INVISIBLE
power-off
power-on
offline
online
master
enable
3-46 Service Processor
Table 3-35. HC Subcommands (cont'd)
arg2 arg3 arg4
rowz
- -
Table 3-36. HC State Display Strings
Description
Indicates that a component is defined as non-existent (i.e. the iSP manages a
component as if it does not exist).
The iSP manages a component as if it exists, but it does not exist when seen
from the iSP due to failure or other reasons.
Once it is recognized by the iSP (regardless of auto detection or manual setting),
it will be managed as if it exists unless you delete it explicitly using the "delete"
command.
Indicates that the power supply (DC) is OFF.
For some components, the power supply (DC) becomes ON when AC is
supplied.
Indicates that the power supply (DC) is ON.
For some components, it is overwritten by the following state display.
Indicates that the power supply (DC) is ON and a component is not configured in
the software (OS or BIOS).
This applies to the CELLV Board, XIC/XBR Board, PCIV/PCIX Unit, and their
subcomponents.
Indicates that the power supply (DC) is ON and a component is configured in the
software (OS or BIOS).
This applies to CELLV Board, XIC/XBR Board, PCIV/PCIX Unit, and their
subcomponents.
This is valid only for the state display of the ISP-C Board. Always Indicates that
it is operating as the master.
Indicates that the component itself is enabled (used for system operation).
Description
Clears the memory bit error counters of ROW.
"x" is the physical CELLV Board number (0-3).
"y" is the MMC number (0-1) within the CELLV
Board.
"z" is the ROW number (0-3).
Each ROW has 3 counters. 3 counters are
cleared at the same time.
[Types of error counters]
Single bit error counter:
Counts in the unit of DIMM in the ROW.
Multi bit counter:
Counts in the unit of the ROW.
This subcommand can be executed in the AC
POWER ON state or DC POWER ON state.