NEC 1080Xd User Manual page 90

cmd arg1
enable
(cont'd)
cellx
procxy
mmcxy
3-40 Service Processor
Table 3-35. HC Subcommands (cont'd)
arg2 arg3 arg4
serialx - -
[all] - -
cxiy - -
- - -
[all] - -
rowz
- -
Description
Enables the serial controller part within the XBC
chip.
"x" is the serial controller number (0-3).
A partition requires a serial controller. When a
partition contains plural CELLV Boards, a serial
controller is selected from available serial
controllers automatically.
Enables the CELLV Board.
"x" is the physical CELLV Board number (0-3).
When the second argument is omitted, only the
CELLV Board is enabled, and the states of any
other subcomponents do not change. In this
case, operation is rejected if some required
components are disabled.
When "all" is specified as the second argument,
not only the CELLV Board but also its
subcomponents become enabled.
Enables the XBC interface part within the
CELLV Board.
"y" is the interface part number (0-1).
For information on the relationship between the
CXI within the CELLV Board and the CXI within
the XBC chip, refer to "cxix" of "xbcx" in
"enable".
Enables the Processor.
"x" is the physical CELLV Board number (0-3).
"y" is the Processor number (0-3) within the
CELLV Board .
Enables the MMC.
"x" is the physical CELLV Board number (0-3).
"y" is the MMC number (0-1) within the CELLV
Board.
When the second argument is omitted, only the
MMC is enabled, and the states of any other
subcomponents do not change.
When "all" is specified as the second argument,
not only the MMC but also its subcomponents
become enabled.
Enables the ROW.
"z" is the ROW number (0-3).
DIMM is not controlled individually.
DIMMs are automatically detected at the time of
startup.