Remote Administration; Service Call - Siemens HiPath 1100 Programming Manual

General settings
Step by step
qmmh
116
dd
= Recognizes all slots (default)
de
a
w
r
Press this key.
Initial status for programming mode.
When the "00" option is selected, the system detects
the components as described on
This means that if a numbering sequence for analog
lines/extensions has previously been configured, it will
be changed when an S
added.
Example 1: In a HiPath 1150 system that has only an
MB Module (2 external lines and 10 analog extensions)
the numbering pattern will be 801 and 802 for analog
trunks, and from 11 to 20 for analog extensions. When
a S is added you have:
0
- 803 to 806 for the digital lines
- 21 to 25 for S
Example 2: for a HiPath 1190 system:
MB + EB 210 + S
801 to 802 - analog trunks
101 to 110 - analog extensions
803 to 812 - S
111 to 115 - S
If a specific slot is selected (01 to 20), the previous num-
bering will be maintained and the system will only de-
tect the module.
The modules can only be connected/disconnect-
ed when the system is turned off.

Remote administration

Service call

This feature allows you to call a service center and let
administration be carried out remotely, through the call
established.
Enter this code.
fd
= Recognizes the specific slot
Module or a TME1 Module is
0
extensions
0
- 5 ports
0
digital lines
0
extensions
0
page 17.