Call Detail Report Through Serial Interface - Siemens HiPath 1100 Programming Manual

Report
Step by step
ejk
Wait 5 seconds
ddj
q
138
In the default setting a digit sequence is not configured.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
p
Enter the sequence of digits (up to 4) for the numbers
to be recorded.
w
Wait for a confirmation tone.
Initial status for programming mode.
Call detail report through serial inter-
face
This setting specifies whether call detail report will be
done through a serial interface or a modem.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
r
Activate/Deactivate call detail report through a serial in-
or
terface:
q
= Activated
r
= Deactivated (default)
w
Initial status for programming mode.