Modem Extension; External-To-External Transfer - Siemens HiPath 1100 Programming Manual

Step by step
dli
dme
q

Modem extension

This setting specifies the extension where the modem
will be connected for serial remote access.
By default, no extension is configured.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the extension number (e.g. 11/101).
w
Initial status for programming mode.

External-to-external transfer

This feature allows a specified extension to transfer an
external call (incoming or outgoing) to another external
call.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the extension number (e.g. 11/101).
w
r
Activate/deactivate transfer:
or
q
= Activated
r
= Deactivated (default)
w
r
Press this key.
Initial status for programming mode.
An external-to-external transfer can only be
made when at least one of the lines is a digital
line and one of the calls is outgoing.
An external-to-external transfer over an analog
line is terminated in the following three situa-
tions:
• Elapsed timeout for external-to-external con-
nection (Code 218)
• When a busy signal is detected
• Type of answering signal (Code 158).
Programming an extension
91