Call Detail Report Through Serial Interface - Siemens HiPath 1100 Series Programming Manual

Call Detail Report Manager
Step by Step
Wait 5 seconds
*
106
In the default setting a digit sequence is not configured.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
6 7
Enter the sequence of digits (up to 4) for the numbers
to be recorded.
Wait for a confirmation tone.
Initial state for Programming Mode.
Call Detail Report through Serial Inter-
face
This setting specifies if Call Detail Report will be done
through a serial interface or a modem.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 0 6
or Activate/Deactivate Call Detail Report through a serial
#
interface:
= To activate
*
= To deactivate (default)
#
Initial state for Programming Mode.
CommServer does not work when this item is
active.