Updating Date/Time Over An Isdn Line; Call Charges; Call Charge Unit - Siemens HiPath 1100 Series Programming Manual

General Programming
Step by Step
*
82

Updating Date/Time over an ISDN Line

This setting allows automatic synchronization of the
system's date and time during an external call over an
ISDN line.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 3 8
or Activate/Deactivate synchronization:
#
* = To activate (default)
= To deactivate
#
Initial state for Programming Mode.

Call Charges

Call Charge Unit

To show call charges in currency units you must specify
a call charge factor. Pulses are multiplied by this factor.
A Call Charge unit consists of a pulse sent over a line by
a public exchange to provide and display call charge
information according to the type of call (local, DDD,
International, etc.) and other criteria determined by the
carrier.
The default value is the "0" comma slot and the "00001"
factor.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
9 5
Set the Call Charge Factor (5 digits).
When you restore the default setting (99), the
date the SW was generated will be displayed.
The time displayed will be 12:00.
For the HiPath 1120 system a Fax/DID module is
required for showing a Date/Time stamp on
system telephone displays