External Line Present; Waiting Time For A Second External Analog Line Attendant - Siemens HiPath 1100 Series Programming Manual

Programming an External Line
Step by Step
0 0
42

External Line Present

System slots that are not connected to an external line
should be configured as "unavailable."
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 7 9
Enter a number for an external analog or digital line
(e.g., 801).
* or Present/Absence of an external line
#
*
#
Press this key.
#
Initial state for Programming Mode.
Waiting time for a second
External Analog Line Attendant
With this feature a call rings directly and immediately at
the First Attendant. After a specified timeout the call is
routed to the Second Attendant for that line
(
The default configuration is set to 30 seconds.
Required: Programming Mode must be active (*95
31994).
0 8 3 Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
... Enter the activation timeout (00 to 99 in 5-second incre-
9 9
ments) where 00 = 0 seconds... 06 = 30 seconds
(default), etc.
Initial state for Programming Mode.
= Present (default)
= Absent
In the case of an external ISDN line, if the setting
is configured as Absent two interfaces will be
disabled.
For digital lines (E1 CAS) you must program the
TME1 Module using the HiPath 1100 E1 Trunk
Manager application.
page 18).