External Line Prefix; External Number Registration - Siemens HiPath 1100 Series Programming Manual

Programming a Digital Trunk
Step by Step
1
0 ...
0 1
...
0 0 1
122

External Line Prefix

This setting specifies the prefix for the PABX external
lines, for domestic and international calls. By default,
the type of a programmed called is not specified.
Required: Programming Mode must be active (*95
31994).
8 9 Enter the code for programming.
or Select the type of call:
2
= National
1
2
= International
Enter the line prefix (up to 5).
Press this key.
#
Initial state for Programming Mode.

External Number Registration

To use the Attendant feature each external number
must be registered to a specific slot.
If the prefix (Code 089) for these numbers has already
been configured, only the final digits need to be regis-
tered.
By default, no digits are specified.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
9 1
Enter the slot (001... 140).
1 4 0
Enter the DID number (up to 20 digits).
Press this key to confirm the entry.
#
(After entering 20 digits, the entry mode exits automat-
ically.)
Enter the next slot.
1 4 0
or
Press this key.
#
Initial state for Programming Mode.