Uploading The Sw Update; Setting A System Password - Siemens HiPath 1100 Series Programming Manual

General Programming
Step by Step
h h
88

Uploading the SW update

This setting specifies when the data downloaded will
be uploaded to the system's memory.
When this upload is in progress (during approximately 3
minutes) the telephone operates as usual.
The default setting specifies for data to be transferred
at 00:00 hours.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 9
: Enter the hour (00 to 23) and the minutes (00 to 59) for
m m
starting the uploads.
Initial state for Programming Mode.

Setting a System Password

The system's Programming Mode is protected by
password against unauthorized use. The default
password is "31994." This password can be changed.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
8 0
Enter a new system password (5 digits).
Confirm the new password by entering it again (5
digits).
Initial state for Programming Mode.
For future reference it is recommended that you
write down your password and store it in a safe
place. If you forget your password, consult a
support technician to obtain access to program-
ming.