Siemens HiPath 1100 Series Programming Manual page 92

General Programming
Step by Step
0 0
92
... Enter the slots for the new modules:
2 0
= Detects all slots (defaults)
0 0
to
0 1
Press this key.
#
Initial state for Programming Mode.
•
•
This means that if a numbering sequence for
analog lines/extensions has been previously
configured it will be changed when a S
or a TME1 Module is added.
Example 1: In a HiPath 1150 system that has
only a MB Module (2 external lines and 10 analog
extensions) the numbering pattern will be 801
and 802 for external analog lines, and from 11 to
20 for analog extensions. When a S
you have:
- 803 to 806 for external digital lines
- 21 to 25 for S
Example 2: for a HiPath 1190 system:
MB + EB 210 + S
801 to 802 - External analog lines
101 to 110 - Analog extensions
803 to 812 - S
111 to 115 - S
If a specific slot is selected (01 to 20), the previ-
ous numbering will be maintained and the
system will only detect the module.
= Detects only the specified slot
2 0
The modules can only be connected/discon-
nected when the system is turned off.
When the "00" option is selected, the system
detects the components as described on
page 14.
extensions
0
- 5 ports
0
external digital lines
0
extensions
0
Module
0
is added
0