S0 Ports - Siemens HiPath 1100 Series Programming Manual

Step by Step
, ,
0 1 0 2 0 3
, ,
0 1 0 2 0 3
S Ports
0
This setting specifies the operating mode for the S
module maximizing the system's port usage.
This option is best for the HiPath 1190 due to its high
port capacity. The goal is to obtain the greatest possible
number of extensions/external lines allowed according
to the following port detection rules:
• External line and extension (default): Each port will
decrease the number of external line slots by 2 and
extension slots by 1. The connection may be PP ,
PMP or S
• External line only: Each port will decrease the num-
ber of external line slots by 2. The connection must
be PP or PMP . If it has been previously configured as
S
0
reversed to PP (which is the default).
• Extension only: Each port will decrease the number
of extension slots by 1. The connection must be a S
Bus line. If it has been previously configured as PP
or PMP , the connection will be automatically
reversed to S
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 6 2
or
Enter the S
1 1
... Select an operating mode:
1 3
= External line and extension (default)
1
= External line only
2
= Extension only
3
or Enter the S
1 1
or
1.Enter the slots for the modules: HiPath 1120 (02), HiPath 1130/1150
(03), and HiPath 1190 (01 and 11).
2.Enter the slots for the modules: HiPath 1120 (02), HiPath 1130/1150
(03), and HiPath 1190 (01 and 11).
Bus line (see item "Mode of Operation").
0
Bus line, the connection will be automatically
Bus line.
0
After completing the configuration, the system
must be restarted.
Module slot on the system
0
Module slot on the system
0
Programming a Digital Trunk
1
.
2
.
0
0
117