Siemens HiPath 1100 Series Programming Manual page 22

Main Configurations
Step by Step
or
1
0 1
Wait 5 seconds
or
1
0 1
Wait 5 seconds If no new number is entered after 5 seconds, the
22
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
2 3
or Enter the Denied List number you want to delete.
2 3
...
Enter the list entry of the number to be denied access.
3 5
Enter the number that will be denied access (up to 10
digits).
Warning: Enter the number without the external access
code.
Wait for a confirmation tone.
Initial state for Programming Mode.
Deleting Numbers from the Denied List
Required: Programming Mode must be active (*95
31994).
2 3 Enter the code for programming.
or Enter the Denied List number you want to delete.
2 3
... Enter the list entry number of the number to be delet-
3 5
ed.
content of that entry is removed.
Initial state for Programming Mode.
Permission Lists
There are three Permission Lists that can be configured
with different telephone numbers and individual exten-
sion prefix combinations (enter the number without the
external access code).
•
•
•
To change a blocked number simply enter its list
entry number and the new number.
Permission List 1 (COS 4) with 4 entries
Permission List 2 (COS 5) with 10 entries
Permission List 3 (COS 6) with 25 entries