Getting Started; Turn On Web Server - Siemens OZS164 SERIES WEB SERVER Commissioning Instructions

Turn on web server

Note
12 / 108
Siemens
Building Technologies
2.2

Getting started

2.2.1 Turn on web server
Connect the web server to the power supply and then to the PC:
1. Connect the power supply to turn on power on the web server. The web server
is operational when the green
2. Check additional displays:
• LED A
:
Green light if LPB/BSB bus power supply is available. Check the LPB/BSB
bus wiring and setting for the bus power supply on the bus device if no bus
power supply is available.
• LED
:
Dark if no fault is pending. You can resolve pending faults later (see
Section 2.9.1).
3. Plug the supplied USB cable into the web server and the PC and start the PC.
The PC recognizes the web server as a USB device. Otherwise, the RNDIS
driver is not yet installed.
OZS164..
OZW772.01
0.2.150
4. The RNDIS driver is installed automatically if the PC is connected to the
Internet and no RNDIS driver is installed. The installation wizard will guide you
through installation.
You can also manually set up the RNDIS driver (see Section 6.3.3).
Web server
Commissioning
LED is lit.
LPB/BSB
CE1C5711en
25.08.2010