Table of Contents
Advertisement
The Peripherals Menu
Model 1630A/D/G
Rear Panel Port :
Selects control signal to be supplied through the rear panel BNC output PORT to an
external device, as follows:
Beeper :
[Pulse on State Tracepoint] - analyzer outputs 15-nsec TTL positive pulse when it
finds state tracepoint .
[High til State Tracepoint] - after run start, analyzer outputs TTL high until it finds
state tracepoint . Then it switches TTL low .
[Low til State Tracepoint] - after run start, analyzer outputs TTL low until it finds
state tracepoint . Then it switches TTL high .
[High on Last Sequence] -analyzer outputs TTL high when it is searching for the last
term in a trigger sequence .
[High on Timing Pattern] - analyzer outputs TTL high as long as the timing trigger
pattern occurs for longer than the specified valid pattern duration .
[Constant High] - analyzer outputs TTL high .
when [On], the analyzer will beep whenever it completes a measurement, and
whenever itflashes an error or warning message on screen . When [Off], the analyzer
will not beep at any time .
1630G System [Peripherals] Specification Menu
System Specification ------------------------------------------
lock
.
Cset :
HP-IL : External Controller
HP- IB : 16BOG is controller
Logic analyzer HP-IB address : 00
Printer HP -IB address :
Disc
HP-11) address :
02 No
Disc
Print non-waveform me
-Rear panel port :
Beeper :
Save configuration in internal storage :
Figure 8-2 . 1630G System [Peripherals] Specification Menu
Without Internally Stored Information
Clock Set:
field used by analyzer to identify when information is captured into memory or
stored on the disc . Enter [month] day year hou r: mi nute :second. Once set, this clock
will continue to keep time as long as analyzer power is on . Once any entry is made in
the clock set field, the entire setting must be properly made .
Hide quick links:
Advertisement
Table of Contents
