Figure 4-9. Default State [Relocation] Format Specification Menu - HP 1630A Operating And Programming Manual

Model 1630A/D/G
State Measurements
State Format Specification____________________________________ .
for label ®
Calculator
Module Starting
Mame Value
= 0000
Figure 4-9. Default State [Relocation] Format Specification Menu
3. Select [ADDR] for the label field . Only one label at a time may be used in the [Relocation] mode . By
naming ranges in the [ADDR] label, routines that are executing may be identified in the State Listing .
4. Move the cursor to the abs 0000 field in the Module Name column . Enter the module name KEYBD and
the starting address value in the next column .
a . Move the cursor to the first field under Calculator and enter the starting address for the module
name .
b. Move the cursor to the middle field of Calulator and enter the number of addresses used for the
module .
c . The last number in the Calculator field shows the first address of unnamed code after the module .
Use this address as the starting address of the next module name .
5. There is code between the modules KEYBD and TIME which can be labeled module A to differentiate it
from the KEYBD and TIME modules. Move the cursor to the Module Name column and add module A.
Use the address determined by the calculator for the starting address.
6. Continue to INSERT the rest of the code modules until the State [Relocation] Format Specification
looks like figure 4-10 .
7 . Press LIST . Change the base field for ADDR with the NEXT[] key to [REL+HEX]. Now the state list for
the ADDR label includes the relocatable module name and the offset addresses referenced from the
beginning of the module (in hexidecimal base) . The new state listing is shown in figure 4-11 . In figure 4-
11 the trigger is now TIME+0010 which means the trigger is located 10 addresses into the TIME module .