Using A Controller To Operate The Analyzer And Printer - HP 1630A Operating And Programming Manual

Using A Printer Model 1630A/D/G
9 . You can stop the print before the entire 1 K memory has been printed, if desired . To do this, press the
analyzer STOP key . When you press the STOP key, the analyzer will stop sending new information to
the printer buffer. The information for the lines on screen will already be in the printer buffer . The print
will continue until the last line of the present display is printed . Then it will halt .
USING A CONTROLLER TO OPERATE THE ANALYZER AND PRINTER
Reset the analyzer address switches to the HP-113 CONTROLLED or HP-IL CONTROLLED positions, as
applicable, and cycle the analyzer LINE power . Check to see that the SYSTEM [Peripherals] menu shows that
the analyzer is controlled and that it lists the desired address . Refer to appendix C for the complete list of
device-dependent commands for controlling operation of the analyzer .
In the controlled mode, the PRINT key can still be used to obtain hard copy from a printer . If you press the
PRINT key (or "PR" sent from controller), the analyzer must be addressed to talk and the printer addressed to
listen before the print will occur .