Mitsubishi Electric GOT 1000 Series Manual page 110

Execute program before (after) action
Program execution destination
Command line
Check return value
Wait for execution completion
(1) Execute program before action, or Execute program after action
(a) Set whether or not to enable program execution before or after execution of actions.
(b) When [Execute program before action] or [Execute program after action] is enabled, make the setting
described in this section (2) and subsequent sections.
(2) Program execution destination
Select an application server to be accessed.
(3) Command line (Up to 127 characters)
Enter a command line for the program that is executed on the application server computer.
For characters that can be used for command lines, refer to the following:
Appendix.1.1 ASCII code table
*1
*2
6 - 34 6.7 Job Settings
Item
Set whether or not to enable program execution before or after execution of actions.
Select an application server to be accessed.
Enter a command line for the program that is executed on the application server computer. (Up to
127 characters)
Set whether to check the return value or not.
Set whether or not to wait for execution completion of the program before executing the next
processing.
Programs that need to be run with administrator privileges (by a user in Administrators group) are not executable.
To execute a program including any displays, place the application server computer into the logon status.
Description
*1*2