Got Internal Device (Gs); Got Internal Device List; Mes Interface Function Area - Mitsubishi Electric GOT 1000 Series Manual

3.4 GOT Internal Device (GS)

3.4.1

GOT internal device list

The list of the GOT internal devices (GS) used for the MES interface module is shown below.
POINT POINT POINT
(1) For details of any other GOT internal devices (GS) than the shown areas used for the MES interface function,
refer to the following manual.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
(2) Values stored in the GOT internal devices (GS) are cleared to 0 when the GOT is powered OFF and then ON
or is reset.
GS Application
265
266 to 272
273
MES interface
function
274
area
275
670
671
672 to 675
3.4.2

MES Interface Function area

This section explains the details of the special registers used for the MES interface function.
(1) SNTP time synchronization setting status (GS265)
(a) The setting status of the SNTP time synchronization setting is stored.
For the SNTP time synchronization setting, refer to the following.
6.9.1 Setting items in SNTP time synchronization setting
0: [SNTP time synchronization setting not exist/failed]
1: [Synchronize with SNTP]
(b) When the "Synchronize using SNTP" box is checked in the Option setting
This area is set when the clock time information was obtained from the SNTP server computer.
If it could not be obtained from the SNTP server computer, this area is not set since the operation for
selection of [Synchronize with PLC CPU time] is performed (The time is synchronized with the time of the
PLC CPU).
SNTP time synchronization setting status
1: [Synchronize with SNTP]
0: [SNTP time synchronization setting not exist/failed]
SNTP time query result
Use prohibited
Monitoring interval timeout count
No. of trigger buffer data
Trigger buffer overflow count
Trigger buffer overflow flag for a job
Name
3.4 GOT Internal Device (GS)
1
2
3
Initial Reference
value section
0
3.4.2
4
0
- -
0
0
3.4.2
0
5
0
6
7
8
3 - 7