Sip System Information Setup - NEC SL 1000 Programming Manual

SL1000/SL1100
Level:
SA
Description
Use Program 10-28 : SIP System Information Setup to set up basic SIP trunking.
Program
10 Input Data
Item
No.
01 Domain Name
02 Host Name
03 Transport Protocol
04 UserID
05 Domain Assignment
06 IP Trunk Port Binding
Conditions
None
2-34
Program 10 : System Configuration Setup
Item Input Data
Up to 64 Characters
(ex. : UserID@Host-
Name.DomainName)
Up to 48 Characters
(ex. : UserID@Host-
Name.DomainName)
0 = UDP
1 = TCP
Up to 32 Characters
When assigning the
User ID, the ID may con-
tain only alpha charac-
ters. (A space and/or
special characters are
not allowed in the User
ID field).
(ex. : UserID@Host-
Name.DomainName)
0 = IP Address
1 = Domain Name
0 = Disable
1 = Enable

10-28 : SIP System Information Setup

Description
Set the domain name of the SIP-URL.
Set the host name of the SIP-URL.
Set the protocol for the connection.
User ID in the SIP Invite Setup message.
Use it for outbound caller ID information if
no information is assigned in commands
21-17, 21-19, 15-16, 14-12 and 10-36. A
call cannot be completed across the span
if there is no outbound CID info. The rea-
son for this is: the from and display portion
of the invite message would be blank, and
it would not know where the call originated
from.
If the information from Telco was a domain
name (siptrunk@sip.com) then set to do-
main. If the information for Telco was a IP
address then set to IP Address.
Trunk port binding is only used for SIP
trunks to the provider in Non-Registration
Mode only. When this is disabled, an in-
bound call comes in and follows your DID
routing but it comes in on the first available
trunk. When enabled, the inbound call
comes in and follows your normal DID
routing but maps to that specified trunk. If
that trunk is busy, it sends back a busy un-
less you build a hunt group. To build the
hunt group, it references command
14-12-02 (pilot register ID). This then
points you to command 10-36-02. All the
numbers with the same pilot are in the
same hunt group.
Program 10 : System Configuration Setup
ISSUE 3.01
Default
No Setting
No Setting
0
No Setting
0
0