Batch Read (Command: 0613) - Mitsubishi Electric MELSEC IQ-R series Reference Manual

Batch read (command: 0613)

Read data from the buffer memory of the host station (supported device).
Message format
The following shows the message format of the request data and response data of the command.
■Request data
Command Subcommand
■Response data
The value read from the buffer memory is stored. The data order differs depending on the type of code, ASCII code or binary
code.
Page 154 Read data, write data
Data specified by request data
■Command
ASCII code
0 6 1 3
30 36 31 33
H H H H
■Subcommand
ASCII code
0 0 0 0
30 30 30 30
H H H H
■Start address
Specify the buffer memory start address to be read. (Page 153 Start address)
■Word length
Specify the word length of the buffer memory to be read. (Page 154 Word length)
Specification range: 1H to 1E0H (480)
Specify the access range within the range of buffer memory.
(Start address + Word length -1)  Buffer memory range
Start address Word length
Binary code
13 06
H H
Binary code
00 00
H H
10 BUFFER MEMORY ACCESS
10.1 Buffer Memory
10
155