Mounting The Drive - ABB ACS150 User Manual

Free space around the drive
The required free space for cooling above and below the drive is 75 mm (3 in.). No
free space is required on the sides of the drive, so they can be mounted side by side.

Mounting the drive

Mount the drive
Note: Make sure that dust from drilling does not enter the drive during the
installation.
With screws
1. Mark the locations for the holes using e.g. the mounting template cut out from the
package. The locations of the holes are also shown in the drawings in chapter
Dimensions. The number and location of the holes used depend on how the drive
is mounted:
a) back mounting: four holes
b) side mounting: three holes; one of the bottom holes is located in the clamping
2. Fix the screws or bolts to the marked locations.
3. Position the drive onto the screws on the wall.
4. Tighten the screws in the wall securely.
On DIN rail
1. Click the drive to the rail as shown in Figure a below. To detach the drive, press
the release lever on top of the drive as shown in Figure b.
a
plate.
b
Mechanical installation
19