Actual signals and parameters
What this chapter contains
The chapter describes the actual signals and parameters used in the Short and the
Long Parameter modes. See section
the parameter mode.
Terms and abbreviations
Term
Actual signal
Def
Parameter
Default values with different macros
When application macro is changed
the parameter values to their default values. The following table includes the
parameter default values for different macros. For other parameters, the default
values are the same for all macros (see section
Parameter mode
Index Name/Selection
1001
EXT1 COMMANDS 2 = DI1,2
1002
EXT2 COMMANDS 0 = NOT SEL
1102
EXT1/EXT2 SEL
1103
REF1 SELECT
1106
REF2 SELECT
1201
CONST SPEED SEL 9 = DI3,4
1301
MINIMUM AI1
2201
ACC/DEC 1/2 SEL
9902
APPLIC MACRO
Definition
Signal measured or calculated by the drive. Can be monitored by the user.
No user setting possible. Groups 01...04 contain actual signals.
Parameter default value
A user-adjustable operation instruction of the drive. Groups 10...99 contain
parameters.
on page 67).
ABB STANDARD
3-WIRE
4 = DI1P,2P,3 9 = DI1F,2R
0 = NOT SEL 0 = NOT SEL
0 = EXT1
0 = EXT1
1 = AI1
1 = AI1
2 = POT
2 = POT
10 = DI4,5
0%
0%
5 = DI5
0 = NOT SEL 5 = DI5
1 = ABB STANDARD 2 = 3-WIRE
Parameter modes
on page
(9902
APPLIC MACRO), the software updates
Parameters and signals in the Long
ALTERNATE
MOTOR POT
2 = DI1,2
0 = NOT SEL
0 = EXT1
0 = EXT1
1 = AI1
12 = DI3U,4D (NC) 1 = AI1
2 = POT
1 = AI1
9 = DI3,4
5 = DI5
0%
0%
0 = NOT SEL
3 = ALTERNATE 4 = MOTOR POT
Actual signals and parameters
63
51
for how to select
HAND/AUTO
2 = DI1,2
21 = DI5,4
3 = DI3
2 = POT
0 = NOT SEL
20%
0 = NOT SEL
5 = HAND/AUTO