Actual Signals And Parameters; What This Chapter Contains; Terms And Abbreviations; Default Parameter Values With Different Macros - ABB ACS150 series User Manual

Actual signals and parameters

What this chapter contains

The chapter describes the actual signals and parameters. It also contains a table of
the default values for the different macros.

Terms and abbreviations

Term
Actual signal
Def
Parameter
E
U

Default parameter values with different macros

When application macro is changed
the parameter values to their default values. The following table includes the
parameter default values for different macros. For other parameters, the default
values are the same for all macros (see section
Index Name/ ABB
Selection STANDARD
1001 EXT1 2 = DI1,2
COMMANDS
1002 EXT2 0 = NOT SEL
COMMANDS
1003 DIRECTION 3 = REQUEST 3 = REQUEST 3 = REQUEST 3 = REQUEST 3 = REQUEST 1 = FORWARD
1102 EXT1/EXT2 0 = EXT1
SEL
1103 REF1 SELECT 1 = AI1
1106 REF2 SELECT 2 = POT
1201 CONST 9 = DI3,4
SPEED SEL
1301 MINIMUM AI1 0.0%
1601 RUN ENABLE 0 = NOT SEL
2201 ACC/DEC 1/2 5 = DI5
SEL
9902 APPLIC 1 = ABB
MACRO STANDARD
Definition
Signal measured or calculated by the drive. Can be monitored by the user.
No user setting possible. Groups 01...04 contain actual signals.
Parameter default value
A user-adjustable operation instruction of the drive. Groups 10...99 contain
parameters.
Refers to types 01E- and 03E- with European parametrization
Refers to types 01U- and 03U- with US parametrization
(9902
3-WIRE ALTERNATE
4 = DI1P,2P,3 9 = DI1F,2R
0 = NOT SEL 0 = NOT SEL
0 = EXT1 0 = EXT1
1 = AI1 1 = AI1
2 = POT 2 = POT
10 = DI4,5 9 = DI3,4
0.0% 0.0%
0 = NOT SEL 0 = NOT SEL
0 = NOT SEL 5 = DI5
2 = 3-WIRE 3 =
ALTERNATE
APPLIC MACRO), the software updates
Actual signals on page 84).
MOTOR POT HAND/AUTO
2 = DI1,2 2 = DI1,2
0 = NOT SEL 21 = DI5,4
0 = EXT1 3 = DI3
12 = 1 = AI1
DI3U,4D(NC)
1 = AI1 2 = POT
5 = DI5 0 = NOT SEL
0.0% 20.0%
0 = NOT SEL 0 = NOT SEL
0 = NOT SEL 0 = NOT SEL
4 = MOTOR 5 = HAND/
POT AUTO
Actual signals and parameters
79
PID CONTROL
1 = DI1
20 = DI5
2 = DI2
2 = POT
19 = PID1OUT
3 = DI3
20.0%
4 = DI4
0 = NOT SEL
6 = PID
CONTROL