ABB ACS150 series User Manual page 118

Parameters in the Long parameter mode
Index Name/Selection
3404 OUTPUT1 DSP
FORM
0 = +/-0
1 = +/-0.0
2 = +/-0.00
3 = +/-0.000
4 = +0
5 = +0.0
6 = +0.00
7 = +0.000
8 = BAR METER
9 = DIRECT
3405 OUTPUT1 UNIT
0 = NO UNIT
1 = A
2 = V
3 = Hz
4 = %
5 = s
6 = h
7 = rpm
8 = kh
9 = °C
11 = mA
12 = mV
3406 OUTPUT1 MIN
x...x
3407 OUTPUT1 MAX
x...x
Description
Defines the format for the displayed signal selected by parameter
SIGNAL1 PARAM.
Signed/Unsigned value. Unit is selected by parameter
UNIT.
Example PI (3.14159):
3404 value
+/-0
+/-0.0
+/-0.00
+/-0.000
+0
+0.0
+0.00
+0.000
Bar graph is not available for this application.
Direct value. Decimal point location and units of measure are the same as for
the source signal.
Note: Parameters 3402, 3403
Selects the unit for the displayed signal selected by parameter
SIGNAL1 PARAM.
Note: Parameter is not effective if parameter
setting is 9 (DIRECT).
Note: Unit selection does not convert values.
No unit selected
Ampere
Volt
Hertz
Percent
Second
Hour
Revolutions per minute
Kilohour
Celsius
Milliampere
Millivolt
Sets the minimum display value for the signal selected by parameter
SIGNAL1 PARAM. See parameter
Note: Parameter is not effective if parameter
setting is 9 (DIRECT).
Setting range depends on parameter
Sets the maximum display value for the signal selected by parameter
SIGNAL1 PARAM. See parameter
Note: Parameter is not effective if parameter
setting is 9 (DIRECT).
Setting range depends on parameter
3405
Display
+ 3 -32768...+32767
+ 3.1
+ 3.14
+ 3.142
3 0....65535
3.1
3.14
3.142
and 3405...3407 are not effective.
3404 OUTPUT1 DSP FORM
3402 SIGNAL1 MIN.
3404 OUTPUT1 DSP FORM
3401 SIGNAL1 PARAM setting.
3402 SIGNAL1 MIN.
3404 OUTPUT1 DSP FORM
3401 SIGNAL1 PARAM setting.
Def
3401 9 = DIRECT
OUTPUT 1
Range
3401 -
3401
-
-
3401 -
-
Actual signals and parameters
117