ABB ACS150 series User Manual page 170

Declaration of Incorporation
(According to
Manufacturer: ABBOy
Address: P.O Box
herewith declare under our
ACS150-...
ACS350-...
ACS355-...
are intended to be incorporated into machinery or to be
machinery covered by Machinery
requirements of the Directive
The technical documentation
instructions are prepared according
been applied:
EN 60204-1:2006
Safety of machinery
and that the following technical standard
EN 60529 (1991
Degrees of protection
The person authorized to compile the technical
Name: Jukka Pari
P.O Box
Address:
The products referred in this Declaration of
2006/95/EC and EMC directive 2004/108/EC.
di r ectives is available from
ABB Oy furthermore declares that
into which it is to be incorporated or of which
be in conformity with the provisions of
legislation, i.e. as a whole, including
ABB Oy gives an undertaking
by the national authorities, relevant information
transmission can be either electrical or
when the information is asked.
intellectual property rights of the
Helsinki, 29.12.2009
rJ7 ) / '
(/ U-/
/Cc-
t
\9nu Virolainen
Vice President
ABBOy
•
..
l l l
Machinery Directive 2006/42/EC)
184, FIN-00381 Helsinki, Finland.
sole responsibility that the frequency converters with type markings:
Directive 2006/42/EC
and its Annex I have been complied
is compiled in accordance
Annex VI and the following
+ A1:2009
- Electrical equipment of
have been used:
+corrigendum May
provided by enclosures (IP codes)
documentation:
184, FIN-00381 Helsinki
Incorporation are
The Declaration
the manufacturer.
it is not allowed to put the
it is to be a component has been found and
the Directive 2006/42/EC and
the equipment referred to
to the national authorities to
on the partly completed
paper format and
This transmission of information shall be without prejudice to
manufacturer.
.
• • •
l l
Street address: Hiomotie 13,
assembled with other machinery to constitute
and relevant essential health and safety
with.
with part B of Annex VII, the assembly
harmonised European standard
machines- Part 1: general requirements
1993 +amendment A1:2000)
in conformity with Low voltage directive
of Conformi t y according
equipment into service until
with national implementing
in this Declaration.
transmit, in response to a reasoned request
machinery. The
it shall be agreed with the national
has
to these
the machinery
declared to
method of
authority
the
167