Overview - ABB ACS150 series User Manual

58

Overview

The following table summarizes the key functions and displays on the integrated
control panel.
LOC
1a
1.1
1c
OUTPUT
1d
4
2
6
5
8
10
Control panel
No. Use
LCD display – Divided into five areas:
1
a. Upper left – Control location:
LOC: drive control is local, that is, from the control panel
REM: drive control is remote, such as the drive I/O.
b. Upper right – Unit of the displayed value.
A
1b
s: Short parameter mode, browsing the list of parameters.
FWD
c. Center – Variable; in general, shows parameter and signal values, menus or
1e
lists. Also displays alarm and fault codes.
d. Lower left and center – Panel operation state:
OUTPUT: Output mode
3
PAR:
Steady: Parameter modes
7
Flashing: Changed parameters mode
9
MENU: Main menu.
FAULT
e. Lower right – Indicators:
FWD (forward) / REV (reverse): direction of the motor rotation
Flashing slowly: stopped
Flashing quickly: running, not at setpoint
Steady: running, at setpoint
SET
mode).
RESET/EXIT – Exits to the next higher menu level without saving changed
2
values. Resets faults in the Output and Fault modes.
MENU/ENTER – Enters deeper into menu level. In the Parameter mode,
3
saves the displayed value as the new setting.
Up –
4
• Scrolls up through a menu or list.
• Increases a value if a parameter is selected.
Holding the key down changes the value faster.
Down –
5
• Scrolls down through a menu or list.
• Decreases a value if a parameter is selected.
Holding the key down changes the value faster.
LOC/REM – Changes between local and remote control of the drive.
6
DIR – Changes the direction of the motor rotation.
7
STOP – Stops the drive in local control.
8
START – Starts the drive in local control.
9
10 Potentiometer – Changes the frequency reference.
: Fault mode.
: Displayed value can be modified (in the Parameter or Reference