34 Panel Display - ABB ACS150 series User Manual

116
Parameters in the Long parameter mode
Index Name/Selection
3304 DRIVE RATING
0000...FFFF hex

34 PANEL DISPLAY

3401 SIGNAL1 PARAM
0, 101...162
3402 SIGNAL1 MIN
x...x
3403 SIGNAL1 MAX
x...x
Actual signals and parameters
Description
Displays the drive current and voltage ratings.
Value in format XXXY hex:
XXX = Nominal current of the drive in amperes. An "A" indicates decimal
point. For example if XXX is 8A8, nominal current is 8.8 A.
Y = Nominal voltage of the drive:
1 = 1-phase 200...240 V
2 = 3-phase 200...240 V
4 = 3-phase 380...480 V
Selection of actual signals to be displayed on the panel
Selects the first signal to be displayed on the control panel in the Output
mode.
3401
LOC
OUTPUT
Parameter index in group
SPEED. If value is set to 0, no signal is selected.
If parameter 3401 SIGNAL1 PARAM,
SIGNAL3 PARAM values are all set to 0, n.A. is displayed.
Defines the minimum value for the signal selected by parameter
SIGNAL1 PARAM.
Display
value
3407
3406
Note: Parameter is not effective if parameter
setting is 9 (DIRECT).
Setting range depends on parameter
Defines the maximum value for the signal selected by parameter
SIGNAL1 PARAM. See the figure for parameter
Note: Parameter is not effective if parameter
setting is 9 (DIRECT).
Setting range depends on parameter
3404
3405
49 1
.
Hz
FWD
01 OPERATING DATA. For example, 102 =
3408 SIGNAL2 PARAM and
3402 3403
3404 OUTPUT1 DSP FORM
3401 SIGNAL1 PARAM setting.
3402
3404 OUTPUT1 DSP FORM
3401 SIGNAL1 PARAM setting.
Def
0x0000 hex
103
0102
3415
3401
-
Source value
-
3401 -
SIGNAL1 MIN.
-