Operation - ABB ACS150 series User Manual

Operation

You can operate the control panel with the help of menus and keys. You can select
an option, for example, an operation mode or a parameter, by scrolling the
arrow keys until the option is visible on the display and then pressing the
key.
With the
made changes.
The ACS150 includes an integrated potentiometer located at the front of the drive. It
is used for setting the frequency reference.
The integrated control panel has six panel modes:
Parameter modes
parameters mode
in this chapter. When a fault or alarm occurs, the panel goes automatically to the
Fault mode showing the fault or alarm code. You can reset the fault or alarm in the
Output or Fault mode (see chapter
When the power is switched on, the panel is in the Output mode, where you can
start, stop, change the direction, switch between local and remote control, monitor
up to three actual values (one at a time) and set the frequency reference. To perform
other tasks, go first to the Main menu and select the appropriate mode. The figure
below shows how to move between the modes.
49 1
LOC
.
OUTPUT FWD
Output mode (p. 63)
The panel goes automatically
to the Fault mode.
F0007
LOC
FAULT
FWD
Fault mode (p. 127)
After reset the panel returns to
the previous display.
key, you can return to the previous operation level without saving the
(Short parameter and Long parameter modes),
and Fault mode. The operation in the first five modes is described
LOC
Hz
LOC
LOC
LOC
Output
Fault tracing on page 127).
Main menu
rEF
MENU FWD
Reference mode (p. 64)
PAr S
MENU FWD
Short parameter mode (p. 65)
PAr L
MENU FWD
Long parameter mode (p. 65)
PArCh
MENU FWD
Changed parameters mode (p. 65)
mode, Reference mode,
Changed
Control panel
59
and