Toshiba e-STUDIO163 Service Manual page 137

[D] Bypass roller unit
(1) Take off the bypass unit.
P.10-8 "[A] Bypass unit"
(2) Remove 2 screws, and take off the cover.
(3) Remove 1 spring and 2 screws. Then take
off the bracket.
Note:
When installing the bracket, engage the U-
shaped part of each head on both front and
rear arms with each protrusion on the bypass
roller unit.
(4) Remove 1 clip, and take off the bypass roller
unit while sliding it to the front side.
Note:
When installing the bypass roller unit, insert
the shaft into the bushing and the coupling
on the rear side.
December 2005 © TOSHIBA TEC
Fig. 10-14
Fig. 10-15
Clip
Fig. 10-16
e-STUDIO163/203 PAPER FEEDING SYSTEM
10 - 11
Cover
Spring
Bracket
Bypass roller unit
Coupling
Shaft
10