Toshiba e-STUDIO163 Service Manual page 165

(5) Remove the terminal and spring. Then take
off the transfer charger wire.
(6) Remove the cushioning material, disconnect
the terminal and remove the spring. Then
take off the separation charger wire.
Notes:
1. Insert the wire securely into the V-
grooves of the front and rear sides.
2. Do not twist the wire.
3. Do not touch the wire directly with bare
hands.
[N] Transfer unit
Note:
When taking off the transfer unit, take off the process unit first to prevent the drum from light.
(1) Open off the ADU cover.
(2) Take off the transfer unit while pulling the
lever.
(3) Disconnect 1 connector.
December 2005 © TOSHIBA TEC
Cushioning material
Terminal
Spring
Separation charger wire
Fig. 11-26
Fig. 11-27
Fig. 11-28
e-STUDIO163/203 DRUM RELATED SECTION
11 - 17
Transfer charger wire
Transfer unit
Connector
11