Toshiba e-STUDIO163 Service Manual page 97

(3) Take off the CIS case.
Notes:
1. When installing the CIS case, be sure to
fit the shaft of the equipment in the shaft
guide attached on the bottom of the CIS
case.
2. When installing the CIS case, install it so
that the "L" shaped portion of the bottom
of the CIS case comes under the CIS unit
drive belt-1.
[G] CIS unit drive belt-1
(1) Take off the CIS case.
P.6-12 "[F] CIS case"
(2) Remove the tension spring.
December 2005 © TOSHIBA TEC
Fig. 6-21
Shaft
Fig. 6-22
Tension spring
Fig. 6-23
6 - 13
CIS case
Shaft guide
e-STUDIO163/203 SCANNER
6