Toshiba e-STUDIO163 Service Manual page 144

[L] Registration roller clutch (CLT1)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Remove 2 screws and take off registration
roller holder.
Note:
When installing the registration roller holder,
engage the arm of the registration roller
clutch with the stopper of the registration
roller holder.
(3) Disconnect 1 connector and take off the reg-
istration roller clutch.
[M] Pickup solenoid (SOL1)
(1) Take off the registration roller clutch.
P.10-18 "[L] Registration roller clutch
(CLT1)"
(2) Disconnect 1 connector, remove 1 screw,
and then take off the pickup solenoid.
e-STUDIO163/203 PAPER FEEDING SYSTEM
Registration roller holder
Registration roller clutch
Connector
Connector
10 - 18
Fig. 10-34
Fig. 10-35
Pickup solenoid
Fig. 10-36
December 2005 © TOSHIBA TEC