NEC Univerge SV8100 System Hardware Manual page 121
Full-featured ip based communications system
Hide thumbs
Also See for Univerge SV8100:
- Features and specifications manual (2210 pages) ,
- Features & specifications manual (1174 pages) ,
- Programming manual (986 pages)
Table of Contents
Advertisement
UNIVERGE SV8100
Blade
Slot #
System Hardware Manual
Order of
Installation
After the initial powering up of the system, subsequent powering up
or resets do not change the slot identification. System programming
(Program 90-05) must be performed to change the slot identification.
Adding any daughter board to increase the available ports or going to
a higher capacity blade (e.g., CD-16DLCA) may require that the slot
be deleted in programming and the blade reinstalled. In the following
example, to add a daughter board to slot 2, the blade must be
removed, deleted in Program 90-05-01, then reinstalled with the
daughter board attached, otherwise the additional ports are not
recognized. This however, uses new ports for the combined blade –
the initial ports (ports 17~24 using the example below) are not used.
Table 4-2 Adding Daughter Board to Chassis Example
Initial Blade
Blade
1
CD-16DLCA
2
CD-8DLCA
(no daughter
board)
3
CD-16DLCA
—
—
Table 4-1 Extension Blade Installation Order Example
Blade Slot
Number
1
1
2
2
3
4
4
3
Extension
Numbers
200~215
216~223
224~239
—
Blade
CD-16DLCA
CD-16DLCA
CD-8DLCA
PZ-8LCE
CD-8DLCA
Updated Blade
Blade
Blade
Slot #
1
CD-16DLCA
2
—
3
CD-16DLCA
4
CD-8DLCA
(with daughter
board)
Issue 1.0
Extension
Numbers
200~215
216~231
232~247
248~263
Extension
Numbers
200~215
—
224~239
240~255
4 - 5
Advertisement
Table of Contents
