Single Point Status (Sps); Configuring Data Objects; General Information About Configuring Data Objects; Directional Protection Activation Information - ABB COM600 Series User Manual

1MRS756567
3.4.7.4.
3.4.8.
3.4.8.1.
3.4.8.2.
COM600 series, Version 5.0
DNP 3.0 Serial Master (OPC) User's Manual

Single point status (SPS)

Table 3.4.7.4-1 Configurable SPS (for OPC internal data) properties for OPC servers
Property/Para- Value or Value range/ Default
meter
Basic
Common Data SPS
Class
Addresses
Item Tag Path

Configuring data objects

General information about configuring data objects

Object properties of the data objects are listed in the following tables.
When configuring address values for DNP IED data objects, the valid address range is
0 - 65535. If the value is -1, then the address is not available.
Directional protection activation information (ACD)
Table 3.4.8.2-1 Configurable ACD properties for OPC client
Property/ Para- Value or Value range/ Default
meter
Basic
Common Data

ACD

Class
Addresses
Description
Common data class according to IEC
61850
Item tag path for the internal status
information. The internal server tags that
can be used are located in the Attributes
nodes that are located under the root, line,
and IED nodes. When an attribute tag is
referred to in the internal item definitions
below, it is possible to use either the whole
tag path or just the path relative to the IED
(the internal tags are configured per IED);
e.g. Attributes\Diagnostic counters\Trans-
mitted data messages. When the whole
path is used, it must be preceded by a
slash (/) character, e.g. /Channel
Name\Attributes\Diagnostic counters\Trans-
mitted data messages.
Description
Common data class according to IEC
61850.
29