Turning The Transceiver Off - Philips IntelliVue TRx Instructions For Use Manual

Insert batteries
Turning the
Transceiver
Off
RF Auto
Shutoff
c. cessation of sounds, indicating a successful association with the
Information Center.
Sounds at Successful Start-up
Transceiver
performs
Test passed
d. If you hear any other sound sequence, either the device has failed the
automatic Self-Test (in which case you should use a replacement
device), or the device cannot establish contact with the Information
Center (check that a sector has been assigned to the device, and that
the device is within the coverage area).
Turn off the transceiver by removing the batteries. A "No Signal" technical
alarm will be in effect at the Information Center until the device is reactivated or
until Standby is initiated.
The configuration data set by the service provider prior to transceiver use is
retained after battery removal.
When RF Auto Shutoff is enabled (default), the transceiver stops broadcasting a
radio signal in order to prevent interference with other transceivers in use. This
condition occurs if there is no ECG signal for 10 minutes and the SpO
cable is not inserted in the SpO
followed by the "Transmitter Off" INOP will be displayed at the Information
Center. Remove the batteries to conserve battery charge. However, if there is no
ECG signal for 10 minutes but the SpO
not stop broadcasting the signal.
Transceiver
searches for
self-test Information
One beep Two beeps
every 5 sec-
sensor port. The technical alarm, "No Signal",
2
cable is inserted, the transceiver does
2
Turning the Transceiver On/Off
Transceiver
connected
Center Information
Beeping stops
onds
Basic Operation
with
Center
sensor
2
4-3