Continuous Measurement - Philips IntelliVue TRx Instructions For Use Manual

Measuring SpO
2
Continuous
Measurement
8-16
SpO Monitoring
2
Spot Check measurements cannot be made when the transceiver is
Note—
connected to TeleMon or the IntelliVue MP5 Patient Monitor, because only
Continuous measurement is available with these devices.
Step Action
1 Attach the sensor to the patient.
2 Connect the SpO
• The SpO
• A low-pitch tone detecting each pulse is audible (unless
sounds are muted).
3 After approximately 30 seconds, if the measurement was successful,
you'll hear a single beep from the transceiver. The value, with the
measurement time, will be displayed at the Information Center. The
sensor light will extinguish.
If the measurement was unsuccessful, you'll hear a double beep.
Remove the sensor cable and reinsert it to retake the measurement.
The SpO
Note—
Center for 1 hour or until another measurement is taken, with one
exception: If the batteries are removed from the transceiver, the Spot
Check measurement will be erased from the display; however, the
SpO measurements will be available in Trend Review.
2
4 To repeat a Spot Check measurement at the bedside, disconnect
then reconnect the SpO
When the transceiver is configured for Continuous SpO
"Patient Configurable Settings in Telemetry Setup" on page 9-4), use the
following directions to initiate Continuous SpO
Step Action
1 Insert the SpO
sensor light turns on.
2 Attach the sensor to the patient.
cable to IntelliVue TRx
2
sensor light turns on.
2
value and time stamp remain on the Information
2
cable to the transceiver.
2
cable into the IntelliVue TRx
2
+
, and check that:
measurement ((see
2
monitoring.
2
+
, and check that the