Huawei LampSite Installation Manual page 27

LampSite
Installation Guide
l
Issue 02 (2014-05-27)
1. With one hand holding it, align the mounting holes with the installation holes, slowly
push the RHUB into the required position in the shelf.
2. Use a torque screwdriver or Phillips screwdriver to tighten the four M6×16 screws
with a torque of 2 N•m, as shown in
Figure 4-18 Tightening screws
The following describes how to install an RHUB with mounting ears installed in standard
mode:
NOTE
If necessary, request one more person for assistance.
1. Remove the mounting ears on both sides of the RHUB by removing the four M4×8
screws, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
Figure 4-19.
4 Installing an RHUB
4-18.
22