List Of Prru Cables - Huawei LampSite Installation Manual

LampSite
Installation Guide
l
l
l
l
l
Safety
l
l
l

5.7.2 List of pRRU Cables

This section describes pRRU cable connections.
Table 5-7
Table 5-7 List of pRRU cables
Cable
Ethernet
Cable
pRRU RF
Jumper
Adapter
Power Cable
Issue 02 (2014-05-27)
Different types of cables must be separately routed with a minimum spacing of 30 mm and
cannot be entangled.
The cables are bound tightly and neatly and the sheaths of the cables is intact.
The cable ties face the same direction and all cable ties bound at similar positions must be
in a straight line.
The extra length of each indoor cable tie must be cut off. A slack of 5 mm is reserved for
each outdoor cable tie before the extra length is cut off. All cut surfaces are without sharp
edges.
Labels or nameplates are attached to both ends, joints, or turns of cables after they are
installed.
Cables are placed away from sharp objects or wall burrs. If these positions are inevitable,
protection pipes are required for the cables.
Cables are routed away from heat sources, or heat-insulation materials are added between
cables and heat sources.
A clearance is reserved at turns of a cable or the position close to a device, facilitating cable
and device maintenance. The recommended clearance is about 0.1 m.
lists pRRU cables.
One End
Connector
RJ45 connector
RJ45 connector
SMA straight
male connector
C13 female
connector
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
The Other End
Connected Connector
to ...
RHUB/ RJ45 connector
CPRI_E0~CP
RI_E7 port
AC or RJ45 connector
Transmission
port
External Based on the port
antenna TX/ model of the
RX RF port on antenna system.
the pRRU
C14 male Based on the
connector on country and area
the AC/DC where the
adapter connector is
used.
5 Installing a pRRU
Connected to ...
pRRU/
CPRI_E0~CPRI_
E1 port
pRRU/GE port
Antenna system
AC power socket
78