ABB ETL600 Instruction Manual page 229

ETL600
B5LC
DANGER
P1LA
DANGER
DANGER
Caution
hot surface
P4LT/P4LU
DANGER
R1BC
DANGER
O4LE
DANGER
G4AI
DANGER
Troubleshooting
1KHW001489-EN
Make sure that the power supply B5LC is
programmed to the correct voltage of 230 V AC or
115 V AC as described in 1KHL015788 before
connecting the equipment to the power source.
Hazardous voltages and/or hazardous energy level
at the heat sink.
Do not touch during operation.
Heat sink should not be touched with conducting
materials to avoid energy discharges and damage of
the power amplifier.
Hot surface at heat sink
Hazardous voltages and/or hazardous energy level
on the module and the cable.
Do not touch the module and the cable leads.
Hazardous voltages and/or hazardous energy level
on the module and the cable.
Do not touch the module and the cable leads
The phone interface on the module O4LE generates
dangerous voltage up to 100 V. Don't operate the
module without upper and lower cover plate. Do not
touch the open pins of the service phone connector,
the leads of its cable, the pins of the external cable
connector and the leads of the external cable.
Hazardous voltages and/or hazardous energy level
on the module and the cable.
Do not touch the module and the cable leads.
November 2005
ABB Switzerland Ltd
9-3