ABB ETL600 Instruction Manual page 314

ETL600 System Test Report
Test
No. Test procedure
B.5.4 Adjust Tx alarm level
Dialog box: Adjust Tx alarm level
Click Activate Tx alarm level, set
jumper CH and turn
R116 on P1LA till LED on it lights
Tx alarm indication:
State of HW alarm relay after
programmed delay.
Turn potentiometer R116 on P1LA
till LED on it goes off.
Tx alarm indication
State of HW alarm relay after
programmed delay.
Click OK.
B.6 Receiver
B.6.1 Programming of the Rx RF filter
Refer to Rx filter tuning instruction
1KHW001491-EN
Bandwidth =
Bandwidth = 16 kHz
Bandwidth = 32 kHz
Center frequency
B.6.2 Tune Rx RF filter P4RX, if present
Dialog box 'Tune Rx RF filter'
B.6.4 Adjust Rx RF level
Dialog box: Tuning & testing...
Dialog box: Adjust Rx RF level
Follow the instructions in the dialog
box
B.6.3 Tune RF hybrid P3LE
Dialog box: Tune RF hybrid
© ABB Switzerland Ltd
Revision:
_
potentiometer
RF hybrid & - in case of
80W - combiner
Pins 2-3 of V9OT cable
RF hybrid & - in case of
80W - combiner
Pins 2-3 of V9OT cable
8 kHz E5RX
E5RX
E5RX
E5RX
P4RX, P3LL, P4LM
Dialog box
Dialog box
Language: Page:
EN B2/B11
Permissible
Test point value
LED to be ON
LED to be ON
Closed
LED to be OFF
LED to be OFF
Open
Refer to
document
1KHW001491
f =________ kHz
Rx
Refer to doc.
1KHW001491
Value
indicated
in dialog box.
Tuned / default
setting
HE
Test
Units result
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
dBu [ ]
Tuned Default
[ ] [ ] D
Form 1KHW001493-EN
Rev. A