ABB REB650 Manual page 35

1MRK 511 419-UUS A
1.1 Device identification Capabilities
1.1.12 DNP3 XML files Rd
available off-line
○
○
○
*
*
*
1.1.13 Connections ● Serial (complete section 1.2)
supported
● IP networking (complete section 1.3)
○ Other, explain:
1.1.14 Conformance ○
Testing
●
Table 3: Serial connections
1.2a Serial connections Capabilities
1.2.1 Port name: Name
used to reference the
communication port
defined in this section
1.2.2 Serial connection
parameters
● Asynchronous - Data Bits, Start Bit, Stop Bit, Parity
○ Other, explain:
1.2.3 Baud rate ○ Fixed at
● Configurable, range 300 to 115200
○ Configurable, selectable from _____,_____,_____
○ Configurable, other, describe:
1.2.4 Hardware flow control (Handshaking): Describe hardware signaling requirements of the interface. Where a transmitter or receiver is
inhibited until a given control signal is asserted, it is considered to require that signal before sending or receiving characters. Where a signal is
asserted before transmitting, that signal will be maintained active until after the end of transmission. Where a signal is asserted to enable
reception, any data sent to the device when the signal is not active could be discarded.
Table continues on next page
650 series 2.2 ANSI
Point list manual
Wr Filename Description of contents
● dnpDp.xml Complete device profile
○ dnpDPCap.xml Device profile capabilities
○ dnpDPCfg.xml Device profile config values
The Complete Device Profile Document contains the
capabilities, Current Value, and configurable methods
columns.
The Device Profile Capabilities contains only the
capabilities and configurable methods columns.
The Device Profile Config. Values contains only the
Current Value column.
Self-tested, version ________
Independently tested, version
th
Version 2.6 rev1 28 October 2010
Test organisation name
DNV GL
DNP3 protocol implementation
Current value If configurable, list
methods
Not supported
Serial IP networking PST of LHMI
Current value If configurable, list
methods
RS485 PST of LHMI
Asynchronous PST of LHMI
9600 PST of LHMI
(BaudRate)
Section 3
29